Honeywell BCR – DL Scanning Issue
Issue: BCR only inputs "@" symbol into Spillman/Flex DL software.

Resolution Steps:

1. Configure BCR Manager
   • Open BCR Manager
   • Set the device interface to COM port Mode
   • Close BCR Manager after applying settings
   • Go to System Tray and right click BCR Manager and exit
2. Identify COM Port in Device Manager
   • Open Device Manager
   • Locate the Honeywell scanner under Ports (COM & LPT)
   • Note the COM port number assigned
3. Verify Settings in Spillman
   • Open Spillman
   • Navigate to DL Scanning > Properties
   • Ensure scanning is enabled
   • Set the COM port to match what was found in Device Manager
   • Choose Barcode Generic Serial in second drop down
4. Prevent COM Port Conflict on Boot
   • Right Click task bar and click Task Manager
   • Click Startup Apps on left or in hamburger at the top left
   • Click BCR Manager
   • Click Disable at the top
   • This prevents the manager from launching at startup and blocking the COM port needed by Spillman

5. Allow Barcode to Start at Power Up
   • Open G-Manager
   • Click Settings on the left and click Misc
   • For barcode choose to have it start at Startup instead of power saving