Overview

The Start Recording button on the CU-D50 is configured by default to activate all cameras. This can be changed to activate only specific cameras using the instructions below.

Instructions

1. Go to the Main Units page.
2. Select the desired Unit by checking the box to the left of its Unit ID.
3. Click on the Wrench icon.

   

    

    

4. Click on Devices from the left-side of the screen, as shown below.

   

    

    

5. Click the Client Screens tab as shown below.

   

    

    

6. Toggle Start Capture with Master Record Button OFF as shown below.

   

    

    

7. Repeat this action for any additional Client Screens.
8. Press the save button, located at the bottom of the page.

   

    

    

9. A message bubble will appear, prompting confirmation as shown below.

   

    
   Caution:

   By clicking on OK, the changes will be applied to all Units assigned this configuration template. Proceed with caution.
10. If a message bubble appears that says, "WiFi setting is not set. Do you want to continue?", Click OK. This is informative only and does not impact anything.